Assembly and preparation
72
Instructions for use Primus Infinity Empowered SW 4.5n
Connecting the power supply
The mains power voltage must correspond to that
specified on the rating plate at the back of the work-
station:
100 to 240 V
z Plug the mains plug into the mains power
socket.
LED on the front of the workstation lights
up green.
Fuses for auxiliary outlets
If a fuse is tripped (position 0):
z Remedy the fault, then press the switch at the
automatic fuse to the position I.
The fuse is active again.
NOTE
The mains plug must be readily accessible so that
the power supply to Primus Infinity Empowered
can be quickly interrupted if there is a device fail-
ure.
102
0
0
II
0
I
To Next Page
Loading...
