Instruments
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_6_7.31.1.html[11/12/2015 18:40:23]
If the engine trips the rev limiter during a lap, the “OVER REV.” indicator light will come on during display of the lap time.
(9).
DDA data acquisition
This function serves to activate the DDA (Ducati Data Analyzer): in order to acquire data, the DDA must be connected to
the motorcycle wiring loom.
To enable data acquisition, enter the menu and set the “DDA“ function to “On“ by holding switch (1) pressed in position B
“t“ for 3 seconds.
To START and STOP the lap separator press the high beam FLASH button (2) on the left-hand handlebar switch.
If the DDA function is active and the motorcycle is suddenly switched off (Key-Off), the function is switched off
automatically.
Note
Online assistance is available to Ducati Data Analyzer (DDA) owners (http://dda.prosa.com). This service will provide
anything necessary to correctly use the DDA with your PC: both for the device and the software for analysing the
recorded data.
To Next Page
Loading...
