Clutch assembly: clutch cover
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_6B.73.1.html[11/12/2015 18:40:49]
If the bush has been replaced, fully seat the new bush (8) in the slot in the cover using a suitable drift and a press.
If the sealing ring (9) needs to be renewed, fit the new seal into the crankcase cover, positioning it so the side without a
spring is facing the circlip (11).
Before fitting, check that the edges of the circlip groove show no sign of burrs which might otherwise damage the sealing
ring.
Then fit the shim (10) and the circlip (11).
Important
In order for the sealing ring (9) to function correctly, it must have an assembly clearance that allows the circlip (11) to
rotate.
Position the sound-proofing panel (6) inside the clutch-side crankcase cover (1), aligning it with the pin (A) as shown in
the figure.
Place the inner cover (17) on the panel (6), centring it with respect to the pin (A).
Fit the screw (20) with the recommended threadlocker and tighten the screw (20) to a torque of 24 Nm (Min. 22 Nm -
Max. 26 Nm) (Sect. 3 - 3,
Engine torque settings).
To Next Page
Loading...
