Gearbox assembly: gearbox shafts
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_7B.76.1.html[11/12/2015 18:40:50]
Reassembly of the gearbox
To reassemble the gearbox components, please proceed as indicated in Sect. 9 - 9.2 regarding the “Reassembly of the
crankcase halves”.
As a final practical test, ensure that with the gearbox in neutral the front coupling dogs (A) of sliding gears (B) are
equidistant on both sides with respect to the corresponding coupling dogs on the fixed gears (C).
Check also that there is always a small amount of clearance between fork (D) and relative groove (E) on sliding gear (B)
when engaging the gears.
Operations Section reference
Reassemble the engine crankcase
halves
9 - 9.2, Reassembly of the
crankcase halves
Refit the gear interlock plunger 9 - 7.1,
Refitting the pawl assembly
and the gear interlock plunger
Refit the gear selector lever 9 - 7.1,
Refitting the gear selector
lever
Refit the cylinder barrel/piston
assemblies
9 - 5,
Refitting the cylinder/piston
assembly
Refit the cylinder heads 9 - 4.4,
Refitting the cylinder head
assembly
Refit the timing belts 9 - 4.2,
Refitting the timing system
assembly
Refit the timing belt covers 9 - 4.2,
Refitting the timing belt
covers
Refit the engine starter system 6 - 3,
Electric starting system
To Next Page