Crankcase assembly: crankcase halves
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_9B.79.1.html[11/12/2015 18:40:53]
Bring the crankcase halves (3) and (16) together, tapping with a rubber mallet in the area of the shafts if necessary.
Prepare the crankcase screws and insert them in the alternator-side crankcase half (3); note that the screws are of
different lengths.
Ref. Qty Description
22 7 M8x75 mm screws
26 7 M6x35 mm screws
25 2 M6x75 mm screws
Progressively tighten the crankcase screws until fully seated, starting with the screws of the largest diameter (M8).
Insert two M8 screws (22) in the clutch-side crankcase half (16).
Tighten all the screws to the following torque (Sect. 3 - 3,
Engine torque settings):
-the screws (22) first to a snug torque of 19 Nm (Min. 17 Nm - Max. 21 Nm), then to a tightening torque of 25 Nm (Min.
22 Nm - Max. 28 Nm);
-the screws (25) and (26) to a tightening torque of 10 Nm (Min. 9 Nm - Max. 11 Nm).
To Next Page