EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Adjustment/Special Operations Methods 191
REQUIREMENTS FOR PARAMETER BACKUP
#F727 Flash Memory Card (1050073)
(Conforms to PCMCIA Rel 2.1/JEIDA Ver 4.2 (Type II) / 5V Read/Write
operation)
Part # 1050073 (Fujitsu: MB98A81183-15)
Memory card writing utility
(i.e. Adtech CardUT97)
PC (Windows 98)
Parallel interface cable
IPL program
IPL contained in the following directory in the service manual data disk.
Folder: \Prog\Ipl\
File: *******.ROM
Before backing up the parameters to the PC card, the above file must be written to
the Flash Memory Card using the card writing utility:
STEPS FOR BACKING UP PARAMETERS FROM C362DRV BOARD
1. Remove the slot cover (secured by 2 screws) located on Rear Cover.
NOTE: Make sure that the operation panel unit is attached.
2. Insert the Memory card for backup into the Memory card slot (CN20) mounted on
the C362DRV Board and turn on the printer.
NOTE: Install the Memory card surface toward outside of the printer.
3. Confirm that the following message is displayed in the LCD and wait for
processing to be completed.
4. When approximately 15 seconds have elapsed after the Power On message has
been displayed, backup will begin.
5. When the backup is completed, the following message appears.
6. If the completion message of the work, turn the printer off and remove the
Memory card.
C A U T I O N
Use the backup card prepared in this section only for "Stylus Pro
10000/10000CF/10600". Do not use the backup card other than
this product.
Wait:F->M Push:M->F
Flash -> Mcard
C H E C K
P O I N T
During this time, do not press operation panel buttons. If buttons
are pressed, rather than backing up, the download process will
begin (writing data from the memory card to the C362DRV Board
flash memory). Extra caution is needed.
End [Success]
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
