Epson Stylus Pro 10000 - Page 234

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 227
2-6. Pigment ink
Mode for the head selection of pigment ink code
Figure 5-45 showing head number selection menu sequence.
Figure 5-45.
2-7. Cord input for pigment
Mode for the head code input. Cursor is appeared under the input column.
Figure 5-46 showing menu sequence.
Figure 5-46.

Move the cursor to the right with "SelecType" key.
 Move the cursor to the left with "Item" key.
 Cursor move to the left edge when you press the "SelecType" key at the right edge.
 Cursor move to the right edge when you press the "Item" key at the left edge.
Item
Item
Item
SelecType
SelecType
Input Head 1 Code
Input Head 2 Code
Input Head 3 Code
Press the [Enter] key to select
the input mode of Head 1.
Press the [Enter] key to select
the input mode of Head 2.
Press the [Enter] key to select
the input mode of Head 3.
SelecType
Enter
Enter
Enter
Head 1-3 X
R \ \ \ \
Head 1-3 X R
\ \ \ \
Head 1-3 X
R \ \ \ \
End with "Pause" key.
Wait
Exc, Enter Fill
Please Set Ink
Ink Charge
Select the proper value with
"Paper Feed+/-" key.
If the cartridge is not installed, left
hand of the message will appears.
Select the proper value with
"Paper Feed+/-" key.
Select the proper value with
"Paper Feed+/-" key.
Press the [Enter] key to select
the Adjust top menu.
Press the [Enter] key to select
the Adjust top menu.
Press the [Enter] key to select
the Adjust top menu.
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com