Epson Stylus Pro 10000 - Page 261

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 254

[H to Cut] is the distance between the LC#1 to the cutter.
 [E to H] is the distance between the edge sensor to the LC#1 head.
 [R to H] is the distance between the rear sensor to the LC#1.
 When the [Pause] key is pushed with the [Update Parameter?] display screen,
display moves to [Update: Ink parameter].
6. Ink parameter
Update the ink parameter.
Figure 5-90 showing the ink parameter update menu sequence.
Figure 5-90.

When the [Pause] key is pushed with the [Update Parameter?] display screen,
display moves to [Update: Cap position].
Enter
Enter
Init. Fill : Set
Init. Fill : Reset
Update Parameter?
Updating Parameter
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com