Epson Stylus Pro 10000 - Page 360

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Troubleshooting 353
Indicators (LED) List
Stylus Pro 10600 LED indicator table shown in Table 8-49.
Table 8-49. Indicators (LED) List
LED Displayed functions LED Status
Operate
With power ON and in status other than those below
On
While processing data, during power OFF sequence
Blink
Fatal error
Blink
Reset, timer IC reset/NVRAM clear
On
Paper Out
Out of paper, end of roll
On
Difference with roll paper and sheet
On
Paper set lever is released
On
paper is thick for cleaning
On
Paper jam
Blink
Paper cutting error
Blink
Paper not straight
Blink
Paper check error
Blink
Problem with paper output (sheet)
Blink
Fatal error
Blink
Reset, timer IC reset/NVRAM clear
On
Maintenance call
On for 100ms at
intervals of 5
seconds
Pause
Print ready
Off
In SelecType mode
Off
During pause
Off
During ink drying time
Blink
During ink sequence
Blink
Other errors
Off
Fatal error
Blink
Reset, timer IC reset/NVRAM clear
On
Ink Out
Out of specified ink
On
No cartridge for specified ink
On
Wrong cartridge for specified ink
On
Illegal cartridge for specified ink
On
Ink level low
Blink
Fatal error
Blink
Reset, timer IC reset/NVRAM clear
On
Paper Source
Selected paper source
On
Fatal error
Blink
Difference with roll paper and sheet
Blink
Reset, timer IC reset/NVRAM clear
On
Table 8-49. Indicators (LED) List
LED Displayed functions LED Status
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com