EPSON Stylus Pro 10000/10000CF/10600 Revision D
Operating Principles Printer Mechanism Components 68
The explanation of the sensor that is used in paper feed department is as follows.
P_FRONT sensor
Using the reflective optical sensor, it is attached to the paper guide L1 back. This
sensor detects the top of paper.
P_REAR sensor
Using the reflective optical sensor, it is attached to the H top cover back. The
sensor detects end of paper.
P_THICK sensor
Using the photo-interrupter, it is attached to the H top cover right side. The sensor
lever has a pressure/subordinate roller assembly. When paper loading, the lever
position is changed according to the paper thickness. Then the sensor detects the
paper thickness.
NOTE: 0.6-0.7mm form thickness uncertain which detection they become.
P_FRONT sensor
P_REAR sensor
Table 2-5. Paper thick detection
Form kind Paper thickness Sensor output Output voltage
Thin paper 0.6mm or less ON 0.7V or more
Thick paper 0.7mm or more OFF 2.4V or more
P_THICK sensor
Sensor lever
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
