Fagor CNC 8065 - Page 146

Operating manual.
CNC 8060
CNC 8065
7.
JOG MODE. PART CENTERING (MILL MODEL)
·146·
(REF: 1807)
Data returned by the cycle after the measurement.
Once the cycle has ended, the CNC returns the real values obtained in the measurement
in the following arithmetic parameters:
Optionally, in this cycle, it is possible to preset the coordinates to select a new part zero and,
in rectangular parts, rotate the coordinate axes to align the axes with the part.
P296 Inclination angle between the part and the abscissa axis (rectangular part).
P297 Part surface coordinate.
P298 Part center coordinate along the abscissa axis.
P299 Part center coordinate along the ordinate axis.