Operating manual.
CNC 8060
CNC 8065
TOOL AND MAGAZINE TABLE
18.
Tool and tool magazine table.
·305·
(REF: 1807)
the previous or next offset. To change offsets, place the focus on the buttons and press
[SPACE].
Operation type and tool
Regardless of the software installed, it is possible to define both milling and lathe tools. The
tool is defined depending on the operation it can carry out. If it is not the right tool for any
of the proposed operations, it must be assigned the operation "Others".
Once the operation has been selected, the screen will show the available tools. It will show
a help graphic with the selected tool type.
The data to define the geometry of the tool will be relevant to the selected tool. It will only
show the data that makes sense for the selected tool.
Offset number and selection of the previous or next offset. In this case, it will
display the data of the second tool offset.
Operation Tool type
Milling
(A)Flat endmill.
(B)Toric endmill.
(C)Ball endmill.
(D)Disk endmill.
Reaming
(A)Reamer.
Grooving/cutoff
(A)Square.
Drilling
(A)Drill bit.
Boring
(A)Quill.
Turning
(A)Diamond.
(B)Square.
(C)Round.
Surface milling
(A)Surface milling endmill.
Tapping
(A)Cutter.
(B)Tap.
Measuring probe
Others To define the tools that do are not suitable for the proposed
operations.
To Next Page
Loading...
