Fagor CNC 8065 - Page 306

Operating manual.
CNC 8060
CNC 8065
18.
TOOL AND MAGAZINE TABLE
Tool and tool magazine table.
·306·
(REF: 1807)
Axis orientation in turning.
It is defined with an icon that is only displayed when defining a turning (lathe) tool.
The orientation of the axes is determined by the type of lathe (horizontal or vertical), the
position of the turret and the spindle position (on the right or on the left).
Location code or tool calibration point.
It is defined with an icon that is only displayed when defining a turning (lathe) tool.
The location code indicates which is the calibrated tool tip and, therefore, the point controlled
by the CNC to apply radius compensation. The location code depends on the orientation of
the machine axes.
Tool-holder orientation.
It is defined by an icon that is displayed in the following cases.
• On a lathe model, for all the tools.
• On a mill model, only for turning (lathe) tools.
The orientation of the tool holder indicates whether it is a tool for horizontal or radial
machining. For turning tools, the meaning of this icon depends on the orientation of the tool
axes.
Spindle turning direction
Use the following icons to define the spindle turning direction.
The new tools do not have a pre-determined spindle turning direction; during execution, the
spindle turns in the programmed direction (M03/04).
When assigning a turning direction to a tool in the table, the CNC will verify, during execution,
that the turning direction in the table is the same as the one programmed (M03/M04). If the
two directions are not the same, the CNC will display the corresponding error message. The
CNC verifies this every time an M03, M04 or M06.is programmed.
"L" - Tool length
This data is only shown on tools that are not for turning. The dimensions of the turning tools
are defined with the offsets.
Horizontal lathe. Radial machining.
Vertical lathe. Longitudinal machining.
Icon Spindle turning direction
Undefined spindle turning direction.
Clockwise spindle turning direction.
Counterclockwise spindle turning direction.