2. Replacement and adjustment of parts
20020
2/7
20020
Removing covers
NOTE
• A is for QSS-3704/3705/LP7700/LP7900, and B is for QSS-3701/3702/3703/LP7500/LP7600.
• #
##
# is used and − is unused.
No. Name Screw
(Q'ty)
Remarks A B
1 Processor cover 1 6 # -
4-#
2 Sub-tank top cover - ##
3 Processor rear cover 7 ##
4 Processor door 1 2 Remove this after removing the mounting plate of the
processor door 1.
##
5 Processor cover 4 6 ##
6 Processor drive cover 4 ##
7 Conveyor damper cover 2 ##
8 Angle bracket cover - ##
9 Distribution plate cover 3 Remove this after removing processor cover 1. # -
2-#
10 Dryer side cover 4 ##
11 Sorter cover 1 ##
12 Conveyor cover 4 Remove this after removing holder (2) and the conveyor
guide.
##
13 Power supply unit cover 2 Remove this after removing processor cover 1. # -
14 PCB cover 4 Remove this after removing the processor rear cover. # -
15 Print sorter unit lower cover 3 Remove this after removing the processor rear cover. ##
16 Replenisher section cover 2 Remove it after removing the bar of the replenisher section
door.
- #
Remove screws with this mark.
Loosen screws with this mark.
Conveyor guide
11
12
Holder (2)
QSS-3701/3702/3703/3704/3705/LP7500/LP7600/LP7700/LP7900
G085404
Distributed by: minilablaser.com
To Next Page
Loading...