Drive section
1/2
2. Replacement and adjustment of parts
27230
27230
Drive section
Adjusting backlash of the dryer rack (QSS-3701/3702/3703/LP7500/LP7600)
This item varies depending on the model. See the references below.
!
!!
! Procedure
IMPORTANT
• The backlash adjustment is required when you replace the dryer rack.
1. Remove the dryer rack.
2. Remove the duct. (one screw and one washer)
3. Loosen one lock nut and three screws on the drive unit to let the unit move a little.
4. Attach the dryer racks.
5. Keep pushing the plate of the drive unit in the direction of the arrow and turn the adjusting bolt until it
contacts the plate.
IMPORTANT
• Check that the gear of the dryer rack and gear A engage.
Model Reference
QSS-3704/3705/LP7700/LP7900
☞27320 ☞27330
Dryer rack
Duct
G069806
Adjusting bolt
Lock nut
Gear A
Drive unit
G069807
Distributed by: minilablaser.com
To Next Page
Loading...