4. Troubleshooting
40900
4/13
40900
Attention message: F replenishment
No. 00906[F]
It is ready to replace the replenisher cartridge.
Attention message release
YES
Condition
NOTE
• If creating the replenishment solution is completed, this attention message is shown only once when the system starts up.
• When creating replenishment solution on the previous day, this message appears while Start Up Checks are performed.
Replace an empty replenishment cartridge with a new cartridge in advance. When the solution runs out, replenishment solution will be
automatically created which will save you from stopping printing.
It is recommended that cartridges be replaced at the start up of the day.
Check Point
Suffix number Condition
00000 If this system is closed down and started while mixing Replenisher has been completed by a cartridge open
1 Set a new cartridge.
Distributed by: minilablaser.com
To Next Page
Loading...