Frontier LP7500 - No. 00703[Sm] Would You Like to Initialize the Remaining Amount of the Replenishment Package

4. Troubleshooting
40700
4/6
40700
Attention message: SM replenishment
No. 00703[SM]
Would you like to initialize the remaining amount of the Replenishment Package?
Attention message release
YES or NO
• Select YES to bring up the message No. 0704: Press the [YES: Execute] to initialize the remaining amount of the Replenishment
Package.
• Select NO to return to the regular print display.
IMPORTANT
• If the replenishment package is replaced before it becomes completely empty, be sure to initialize the remaining amount
of the replenishment package.
• If the replenishment package is not replaced but attached again, the process will be continued without initializing the
remaining amount of the replenishment package.
Condition
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
Suffix number Condition
00000 Before the replenishment package is completely empty, replenishment package sensor 1 or 2 turns off.
Adjustment failure point Manual No.
Failure in the attaching position adjustment of the replenishment package sensor
☞63300
Failed part Manual No.
Replenishment package sensor ☞63300
SM I/O PCB
☞66600
Processor control PCB ☞66200
Distributed by: minilablaser.com