7/7
6. Electrical parts
66007
66007
Description of PCB (printer section)
(1) If the Link Speed & Duplex is not set to Auto Detect, set it to Auto Detect.
NOTE
• Write down the Link Speed & Duplex setting as needed.
(2) Click OK.
3. If the operation PC and printer I/F main PCB are connected via HUB as an example 1, match the HUB
setting with Link Speed & Duplex.
4. Confirm the network setting of the operation PC.
See Step 7 in 66007.
Distributed by: minilablaser.com
To Next Page
Loading...