376 Upgrade and Maintenance Manual RX2530 M4
System board and components
Figure 283: Removing the TPM spacer
Ê Using a flat nose pliers, press together the hooks on the TPM spacer (1, see
close-up) and remove it from the system board (2).
I If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Ê Install all riser modules, see section "Expansion cards and riser cards" on
page 219.
Ê If applicable, install the OCP module, see section "Installing an OCP
module" on page 213.
16.3.2.3 Concluding steps
Ê "Installing the new system board" on page 405
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 63
Ê "Switching on the server" on page 66
To Next Page
Loading...
