190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
140
Audio And CnS
SYSTEM
oVERViEW
FLiGHT
inSTRuMEnTS
EiSAudio & CnS
FLiGHT
MAnAGEMEnT
HAZARd
AVoidAnCE
AFCS
AddiTionAL
FEATuRES
APPEndiCESindEX
Selecting a NAV frequency using the Touchscreen Controller:
1) Touch the Audio & Radios Button to display the Audio & Radios Screen.
2) Touch the NAV1/NAV2 frequency button to select NAV1/NAV2 for tuning, and display the NAV1/NAV2 frequency
tuning screen.
3) Use the keypad to select the desired frequency.
4) Touch the Enter Button to enter the new frequency as the NAV1/NAV2 standby frequency; or touch the XFER
Button to enter the new frequency as the NAV1/NAV2 standby frequency and transfer it to the active frequency.
Figure 4-20 NAV Frequency Tuning Window
XFER Button
Enter Button
Find Button
Knob function labels
Or:
1)
Touch the Audio & Radios Button to display the Audio & Radios Screen.
2) Touch the NAV1/NAV2 volume slider to select NAV1/NAV2 for tuning.
3) Turn the large and small right knobs to tune the frequency (Large knob increases/decreases MHz; Small knob
increases/decreases kHz).
4) Press the small right knob to enter the new frequency as the NAV1/NAV2 standby frequency; or press and hold
the small right knob to transfer the new standby frequency to the active frequency.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
