190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
141
Audio And CnS
SYSTEM
oVERViEW
FLiGHT
inSTRuMEnTS
EiS Audio & CnS
FLiGHT
MAnAGEMEnT
HAZARd
AVoidAnCE
AFCS
AddiTionAL
FEATuRES
APPEndiCES indEX
Selecting a NAV frequency using the GDU Controller:
1) On the GDU Controller, press the COM/NAV Button to display the COM/NAV Window.
2) Turn the large PFD Knob to move the cursor to the SOURCE field.
3) Turn either PFD Knob to select the desired NAV.
4) Press the ENT Key or the small PFD Knob to accept the selection and move the cursor to the STBY frequency
field.
5) Turn the small PFD Knob one click to activate the editing cursor (flashing).
6) Turn the large and small PFD knobs to tune the frequency (Large knob increases/decreases MHz; Small knob
increases/decreases kHz)
7) Press the ENT Key or the small PFD Knob to accept the selection and move the cursor to the XFER? field.
8) Press the ENT Key or the small PFD Knob to transfer the standby frequency to the active frequency.
Figure 4-21 Frequency Tuning from the GDU Controller
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
