190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
241
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeS inDeX
Figure 5-81 Direct To - Selecting a Manual Course
Course
Selection
Using Touchscreen Controller
Using GDU Controller on PFD
Reselecting the direct course from the current position:
1) From Home, touch Direct To.
2) Touch the Activate ¯ Button to activate the direct-to using the direct course.
Or:
1)
On the GDU Controller, press the ¯ Button to display the Direct To Window.
2) Press the ENT Key or the small PFD Knob to accept the selection and move the cursor to the ACTIVATE? field.
3) Press the ENT Key or the small PFD Knob to activate the direct-to using the direct course.
A direct-to with altitude constraints creates a descent path (and provides guidance to stay on the path) from
the aircraft’s current altitude to the altitude of the direct-to waypoint. The altitude is reached at the waypoint, or
at the specified distance along the flight path if an offset distance has been entered. All VNAV altitudes prior to
the direct-to destination are removed from the active flight plan upon successful activation of the direct-to. All
VNAV altitudes following the direct-to waypoint are retained. See the section on Vertical Navigation for more
information regarding the use and purpose of VNAV altitudes and offset distances.
Entering a VNAV altitude and along-track offset for the waypoint:
1) From Home, touch Direct To.
2) Touch the VNAV Altitude Button to display the keypad.
3) Use the keypad to select the altitude.
4) Touch the Enter Button to accept the altitude, and and return to the Direct To Screen.
5) Touch the VNAV Offset Button to display the keypad.
6) Touch the (Before) - Button or the (After) + Button, if necessary.
7) Use the keypad to select the offset distance.
8) Touch the Enter Button to accept the offset distance, and and return to the Direct To Screen.
9) Touch the Activate ¯ Button to activate the direct-to using the VNAV constraints.
Or:
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
