Garmin G2000 - Page 312

Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A298
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeSinDeX
Viewing available procedures at an airport:
1) From Home, touch Waypoint Info > Airport
2) If necessary, touch the Airport Button to display the keypad and use it to select the airport.
3) Touch the Proc Tab to display the Airport Procedures Screen.
4) Scroll the list if necessary and touch a procedure selection button. The procedure selection screen is displayed
for the selected procedure.
5) Touch the Preview Button, then the Show on Map Button to show the preview of the procedure.
6) Touch the Back Button to return to the Airport Procedures Screen to view another procedure.
7) Repeat steps 4 - 6 as necessary.
Loading an approach into the active flight plan from the Airport Information Screen:
1) From Home, touch Waypoint Info > Airport
2) If necessary, touch the Airport Selection Button to display the keypad and use it to select the destination airport.
3) Touch the Proc Tab to display the Airport Procedures Screen.
4) Scroll the list, if necessary, and touch an approach selection button. The Approach Selection Screen is displayed
on the Touchscreen Controller for the selected approach.
5) Touch the Preview Button, then the Show on Map Button to show the preview of the approach.
6) Edit the approach, if required.
7) Touch the Load Button to insert the approach into the active flight plan.
Loading an approach into the active flight plan from the Nearest Airport Screen:
1) From Home, touch Nearest > Airport
2) If necessary, scroll the list to find the airport and touch the airport selection button to display the Waypoint
Options Window for the selected airport. If the airport is not listed, touch any airport selection button to display
the Waypoint Options Window.
3) Touch the Airport Info Button to display the Airport Information Screen. If in the previous step, the airport was
not listed, touch the airport button and use the keypad to select the destination airport.
4) Touch the Proc Tab to display the Airport Procedures Screen.
5) Scroll the list, if necessary, and touch an approach selection button. The Approach Selection Screen is displayed
on the Touchscreen Controller for the selected approach.
6) Touch the Preview Button, then the Show on Map Button to show the preview of the approach.
7) Edit the approach, if required.
8) Touch the Load Button to insert the approach into the active flight plan.
This manual downloaded from http://www.manualowl.com