Garmin G2000 - Page 58

Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A44
SyStem Overview
SyStem
Overview
FLiGHt
iNStrUmeNtS
eiS
AUDiO PANeL
& CNS
FLiGHt
mANAGemeNt
HAZArD
AvOiDANCe
AFCS
ADDitiONAL
FeAtUreS
APPeNDiCeSiNDeX
SyStem
Overview
FLiGHt
iNStrUmeNtS
eiS AUDiO & CNS
FLiGHt
mANAGemeNt
HAZArD
AvOiDANCe
AFCS
ADDitiONAL
FeAtUreS
APPeNDiCeSiNDeX
3) Touch the GPS CDI button (button displays current GPS CDI range in light blue).
4) Touch one of the following GPS CDI Range Buttons: 0.30 NM, 1.00 NM, 2.00 NM, or AUTO.
com cHannel SPacing
NOTE : 8.33 kHz VHF communication frequency channel spacing is not approved for use in the United States.
Select the 25.0 kHz channel spacing option for use in the United States.
The ‘COM Channel Spacing’ datafield allows the pilot to select 8.33 kHz or 25.0 kHz COM frequency
channel spacing.
Setting COM Channel Spacing:
1) From the Home, touch Utilities > Setup > Avionics Settings.
2) If necessary, touch the System tab.
3) Scroll to and touch the COM Channel Spacing Button (button displays the current spacing setting in light blue).
4) Touch either the 8.33 kHz or 25.0 kHz Buttons.
electronic StaBility & Protection (eSP)
Refer to the Additional Features Section for more information on Electronic Stability & Protection.
Enabling/Disabling Electronic Stability & Protection:
1) From Home, touch Utilities > Setup > Avionics Settings.
2) If necessary, touch the System tab.
3) Scroll to and touch the Stability & Protection Enable Button. Electronic Stability and Protection is enabled when
button annunciator is green, disabled when gray.
The Electronic Stability & Protection feature is enabled on each power cycle.
neareSt airPortS
Nearest airport matching criteria (such as minimum runway length and/or surface type) can be entered to
prevent airports with small runways or runways that are not of appropriate surface from being displayed in
the list as nearest airports . Default settings are zero feet (or meters) for runway length and “HARD/SOFT”
for runway surface type.
Setting the Nearest Airport surface matching criteria:
1) From the Home, touch Utilities > Setup > Avionics Settings.
2) If necessary, touch the System tab.
3) Scroll to and touch the Nearest Airport Runway Surface button (button displays current runway surface selection
in light blue).
4) Touch one of the following runway surface buttons: Any, Hard Only, Hard/Soft, or Water.
This manual downloaded from http://www.manualowl.com