GE Vivid S5 N - 3-6-4 Software Options Configuration; 3-6-4-1 Software Option Installation; 3-6-4-2 On-site Configuration

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-95
PRELIMINARY
3-6-4 Software Options Configuration
3-6-4-1 Software Option Installation
A Password (Software Option String) enables a software option or a combination of software options.
This password is specific for each Vivid S5 N and Vivid S6 N.
3-6-4-2 On-site Configuration
1.) Press CONFIG
(F2) and log on as Adm - see ‘Log On to the System as ADM” on page 4-10.
2.) Select ADMIN
(lower part of window),
3.) Select the SYSTEM ADMIN
tab.
4.) Select NEW
to open the New Key dialog where you type the Software Option Key (Serial String).
5.) Type the Password (Software Option Key).
6.) Press OK
to save the new setting.
7.) Close the Config window.
8.) Restart the scanner after each entry of a new software option.
Figure 3-108 System Admin screen
Figure 3-109 Type Software Option Key
CAUTION
If password is incorrect, please contact your local GE Service representative.
System Admin Tab
New
Admin
Field for Software Option Key (Serial String)