GE Vivid S5 N - 8-2-1-1 Preparations; 8-2-1-2 Order of Cover Removal

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-3
PRELIMINARY
8-2-1-1 Preparations
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in 4-2-3 "Power Shut Down" on
page 4-7.
8-2-1-2 Order of Cover Removal
Remove the system covers in the following order, as applicable:
• Right Side Cover, as described on page 8-4.
• Left Side Cover, as described on page 8-6.
• Right Rear Cover, as described on page 8-10.
• Left Rear Cover, as described on page 8-13.
• Front Cover, as described on page 8-17.
• Bottom Rear Cover, as described on page 8-23.
• DVD Cover, as described on page 8-24.
NOTE: For removal of system accessories, refer to the following procedures:
• “Basket Replacement Procedure” on page 8-20
• “Tray Replacement Procedure” on page 8-22
DANGER
ELECTRICAL HAZARDS EXIST AT SEVERAL POINTS IN THE SYSTEM.
FAMILIARIZE YOURSELF WITH ALL HAZARDOUS VOLTAGES AND
HIGH CURRENT LEVELS BEFORE REMOVING ANY OF THE COVERS.
DANGER
DO NOT WEAR THE ESD WRIST BAND STRAP WHEN REMOVING
PARTS FROM THE POWER SUPPLY UNIT. BEFORE REMOVING ANY
PART OF THE POWER UNIT, TURN THE POWER OFF AND
DISCONNECT THE POWER CORD.
CAUTION
Before removing circuit boards, turn the power OFF and wear the ESD wrist band strap.