GE Vivid S5 N - 8-5-1-3-4 Removing Cables from the Distributions Interface Board (DIB)

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-103
PRELIMINARY
d.) Push the LCD power cable down through the aperture, as shown in Figure 8-123.
8-5-1-3-4 Removing Cables from the Distributions Interface Board (DIB)
1.) Remove the system covers, as described in the following procedures (see also):
• “Left Side Cover Removal Procedure” on page 8-6
• “Right Side Cover Removal Procedure” on page 8-5
• “Front Cover Removal Procedure” on page 8-17
Figure 8-123 LCD Power Cable