GE Vivid S5 N - 8-2-2-3 Right Side Cover Removal Procedure; 8-2-2-4 Right Side Cover Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-5
PRELIMINARY
8-2-2 Right Side Cover Replacement Procedure (cont’d)
8-2-2-3 Right Side Cover Removal Procedure
1) Gripping the recess located near the bottom of the cover (as shown on the left in Figure 8-3), pull
the bottom of the cover out towards you to release it from the lower securing clip.
Figure 8-3 Removing Right Side Cover
2) Pull the top of the cover out towards you, releasing it from the upper securing clip.
3) Remove the right side cover from the system.
8-2-2-4 Right Side Cover Installation Procedure
1) Return the right side cover to the correct position on the right side of the system, carefully aligning
it with the securing clips.
2) Holding the cover by the recess with one hand, push the top of the cover upwards and inwards with
the other hand, until clicks into place.
3) Push the bottom of the cover upwards and inwards, until it clicks into place.
Make sure the cover is correctly seated.
4.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
- “Temperatures Test” on page 7-15
- “Fans Speed Test” on page 7-15
- “Fans Speed Setting Test” on page 7-15
Grip cover here
System with B&W Printer Installed System without B&W Printer