GE Vivid S5 N - 8-2-11-4 DVD Cover Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-25
PRELIMINARY
8-2-11 DVD Cover Replacement Procedure (cont’d)
6.) Pull out and remove the DVD cover.
8-2-11-4 DVD Cover Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the DVD Cover Removal Procedure.
1) Make sure the control console is raised to its maximum height.
2) Return the DVD cover to the correct position on the system, carefully aligning the top of the cover
with the screw holes on the top of the peripheral cage.
3.) Working from the top of the peripheral cage, fasten the two screws (previously loosened) and
tighten securely to fasten the DVD cover in position - see Figure 8-25.
4) Install the front cover, as described in “Front Cover Installation Procedure” on page 8-19.
5) Install the right rear cover, as described in the “Right Rear Cover Installation Procedure” on page 8-12
6) Install the left and right side covers, as described in “Left Side Cover Installation Procedure” on
page 8-7 and the “Right Side Cover Installation Procedure” on page 8-5.
7.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
Figure 8-26 DVD Cover Removed