GE Vivid S5 N - 8-9-7 Digital Color Printer Replacement Procedure; 8-9-7-1 Tools; 8-9-7-2 Time Required; 8-9-7-3 Preparations

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-253
PRELIMINARY
8-9-7 Digital Color Printer Replacement Procedure
NOTE: This section describes removal and replacement procedures only.
For initial installation and configuration instructions, refer to the information provided in
Chapter 3 - System Setup. See “Connecting the Color Video Printer” on page 3-65 and “Configuring
Printing Buttons P1 and P2” on page 3-27.
8-9-7-1 Tools
None
8-9-7-2 Time Required
20 minutes
8-9-7-3 Preparations
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in 4-2-3 "Power Shut Down" on
page 4-7.
8-9-7-4 Digital Color Printer Removal Procedure
1.) Disconnect the USB cable from the scanner rear connectors panel, and from the USB port at the
rear of the printer.
2.) Disconnect the power cable from the power IN socket at rear of the printer, and from the printer
peripherals outlet at the rear of the scanner.
3.) Remove the printer and place on a flat surface (together with the two cables removed).
Figure 8-289 Digital Color Printer