GE Vivid S5 N - 8-9-4 External USB Hard Disk Replacement Procedure; 8-9-4-1 Tools; 8-9-4-2 Time Required; 8-9-4-3 Preparations

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-242 Section 8-8 - Software Loading
PRELIMINARY
8-9-4 External USB Hard Disk Replacement Procedure
NOTE: This section describes removal and replacement procedures, including initial configuration.
8-9-4-1 Tools
Appropriate flat screwdriver and open-ended wrench.
8-9-4-2 Time Required
30 mins
8-9-4-3 Preparations
Shut down the Vivid S5 N / Vivid S6 N ultrasound unit, as described in 4-2-3 "Power Shut Down" on
page 4-7.
8-9-4-4 External USB Hard Disk Removal Procedure
NOTE: Ensure that there is no activity on the drive before you turn it off.
If power is turned off while files are being written to the drive, the files will be corrupted.
1) Switch OFF the power to the unit.
The power switch is located at the rear of the unit - see Figure 8-277 on page 8-243.
2) Disconnect the power cable from the mains power outlet.
3) Disconnect the External USB Hard Disk from the USB port on the Vivid S5 N / Vivid S6 N system.
4) Remove the unit.
NOTE: If the External USB Hard Disk is filled with data, store it in a safe place and label it with the date, and a
note that the drive is full.
Figure 8-276 External USB Hard Disk