GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-241
PRELIMINARY
3.) Connect the USB cable between the USB port at the rear of the MOD Drive and either of the USB
ports (upper or lower) on the scanner rear connectors panel.
4.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
5.) Insert an MO disk in the MOD drive. Then eject and remove the MO disk to check the eject
mechanism functions properly.
To Next Page
Loading...
