GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-38 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
4.) Remove the LCD screen from its plastic frame by releasing 4 retaining screws around the perimeter
of the screen - Figure 8-46.
5.) Lift the LCD screen upwards away from the frame.
Note: If not replacing the cover immediately, temporarily return the monitor to its position on the
control console (refer to the appropriate steps in the “Monitor Installation Procedure” on
page 8-29.
8-3-3-5 Monitor Cover Installation Procedure
1.) Carefully place the LCD screen face downwards in the new frame, then return the 4 retaining
screws (previously removed) to secure the screen in the frame - refer to Figure 8-46.
2.) Place the new monitor rear cover in the correct position on the rear of the monitor and secure it in
with the 4 retaining screws (previously removed) - refer to Figure 8-45 on page 8-37.
3.) Install the monitor on the control console, as described in the “Monitor Installation Procedure” on
page 8-29.
4.) Adhere the appropriate Vivid S5 N or Vivid S6 N system label to the rear of the monitor.
5.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
- “Monitor Movement Test” on page 4-36
- “Monitor Test” on page 4-22
6.) For the next stage of the monitor installation procedure, proceed to the instructions for Image
Quality Calibration, as described in Chapter 6 - Service Adjustments.
Figure 8-46 One of Four Retaining Screws around Perimeter of LCD Screen
To Next Page
Loading...
