GE Vivid S5 N - 8-9-2 DVD;CD-RW Drive Replacement Procedure; 8-9-2-1 Tools; 8-9-2-2 Time Required; 8-9-2-3 Preparations

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-236 Section 8-8 - Software Loading
PRELIMINARY
8-9-2 DVD/CD-RW Drive Replacement Procedure
8-9-2-1 Tools
Use the appropriate Phillips-type screwdrivers as indicated in the DVD/CD-RW Drive replacement
procedure.
8-9-2-2 Time Required
20 minutes
8-9-2-3 Preparations
Shut down the Vivid S5 N or Vivid S6 N ultrasound unit, as described in 4-2-3 "Power Shut Down" on
page 4-7.
8-9-2-4 DVD/CD-RW Drive Removal Procedure
1) Remove the Vivid S5 N or Vivid S6 N left and right side covers, as described in the “Left Side Cover
Removal Procedure” on page 8-6 and “Right Side Cover Removal Procedure” on page 8-5.
2) Remove the Vivid S5 N or Vivid S6 N front cover, as described in the “Front Cover Removal
Procedure” on page 8-17.
3) Remove the bottom rear cover, as described in the “Bottom Rear Cover Removal Procedure” on
page 8-23.
4.) Loosen and remove the two Phillips screws that secure the DVD cover in position (refer to Figure
8-25 on page 8-24) and remove the DVD Cover.
5.) Loosen and remove the two Phillips screws on either side of the securing panel (that holds the
DVD /CD-RW Drive in position), as indicated in Figure 8-269.
.
Figure 8-269 Screws Securing DVD/CD-RW Drive in Position
DVD/CD-RW Drive
Screws this side
not visible in
illustration