GE Vivid S5 N - 8-4-15-4 Speaker Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-94 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
8-4-15 Speaker Replacement Procedure (cont’d)
5.) Loosen and remove the four star-shape screws that fasten each of the Speakers in position, as
shown in Figure 8-102.
6.) Remove the speaker from the Keyboard assembly.
8-4-15-4 Speaker Installation Procedure
1.) Carefully place the new Speakers in the keyboard assembly (refer to Figure 8-107). Make sure each
speaker is correctly positioned (seated properly).
2.) Return and fasten the four star-shape screws (previously removed) to secure each speaker in
position - refer to Figure 8-107. Do not overtighten the screws!
3.) Re-connect the two cables to the Extended Keyboard, as indicated in Figure 8-106 on page 8-93.
4.) Re-fit the Keyboard Bottom Cover, as described in the “Keyboard Bottom Cover Installation
Procedure” on page 8-60.
5.) Install the Keyboard Assembly on the system, as described in the “Keyboard Assembly Installation
Procedure” on page 8-42.
6.) Proceed to perform the following functionality tests:
- 4-3-1-1 "Alphanumeric Keyboard Test" on page 4-18
- 4-3-1-2 "Extended Keyboard and Trackball Test" on page 4-18
- 4-3-1-4 "Speakers Tests" on page 4-21
- 4-3-1-5 "Light Detector Test for Vivid S6 N only" on page 4-22
- 4-3-4-1 "USB Test" on page 4-37
- 10-6-4 "Grounding Continuity" on page 10-23
- 10-6-5 "Chassis Current Leakage Test" on page 10-24
Figure 8-107 Speaker Removal
Speaker
Speaker