GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
4-14 Section 4-2 - General Procedures
PRELIMINARY
4-2-6 Labeling Removable Media
Before you start to format any Removable Media, be sure about what naming convention you will use
for labelling.
• Use a logical name and make sure to physically label each Removable Media.
• Verify that each Removable Media is given a unique name. Maximum eleven (11) characters may
be used for the label name (see note below).
NOTE: Only the following characters and signs can be used when labelling media:
A-Z, a-z, 0-9, “_” and “-”.
Do not use more than 11 characters or signs. Also, do not use spaces or symbols.
• Remember that MO Disks have two sides, Side A and Side B. Each Side must have a unique name.
Example: MO Disks for storing images may be labeled “IMAGE_1A” (Side A on MO Disk #1), “IMAGE_1B
(Side B on MO Disk #2), “IMAGE_2A”...
4-2-7 Formatting Removable Media
This procedure describes how to format an MO Disk or a CD-R disk.
Before you continue, be sure about what naming convention you will use for labelling the Removable Media.
1.) Select Config > Connectivity > Tools.
2.) Select the removable media from the Media pop-up menu.
3.) Enter a name for the removable media in the Label field.
4.) Press Format.
5.) Wait for display of the Information window, indicating that the formatting process is completed.
6.) Press the Eject button on the keyboard or <Alt> + E on the alphanumeric keyboard to display the
Eject Device menu (see Figure 4-8 "Eject Device Menu" on page 4-13).
7.) Select the relevant media.
The selected media is ejected.
Do not eject the CD using the button on the CD drive.
To Next Page
Loading...
