GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-135
PRELIMINARY
8-6-5-4 BEP Removal Procedure
1) Remove the left and right side covers, as described in the 8-2-3-3 "Left Side Cover Removal
Procedure" on page 8-6 and 8-2-2-3 "Right Side Cover Removal Procedure" on page 8-5.
2) Remove the front cover, as described in the 8-2-6-3 "Front Cover Removal Procedure" on page 8-17.
3) Open and remove the cabinet cage assembly and place it on a stable surface, as described in 8-6-
1 "Opening and Removing the Cabinet Cage Assembly" on page 8-109.
4.) Remove the hard disk, as described in the 8-6-4-4 "Hard Disk Removal Procedure" on page 8-122.
5.) Remove the battery, battery bracket and cable, as described in the 8-6-2-4 "Battery Removal
Procedure" on page 8-116 and 8-6-3-4 "Battery Bracket Removal Procedure" on page 8-119.
6) Cut the plastic cable tie wrap, as indicated in Figure 8-165.
.
7) Carefully disconnect the Keyboard cable from the BEP by removing the Phillips screw from the
bracket that holds the cable connector in place - see Figure 8-166. (The Ground cable is on top, so
take care not to damage the wires inside the cable).
Figure 8-165 Location of Cable Tie
Figure 8-166 Keyboard Cable Fastened with Screw
To Next Page
Loading...
