GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-97
PRELIMINARY
5.) Slide the Power cable (the thinner, black cable) through the opening and slide it down
(Figure 8-111).
8-5-1-3-2 Removing Cables from the Keyboard Interface Assembly
1.) Remove the Keyboard from the system, as described in “Keyboard Assembly Removal Procedure” on
page 8-39.
2.) Remove the two Phillips screws securing the white bracket, as shown in Figure 8-112.
Note: A detailed description of the procedure for removing the Alignment Block is described in the
“Monitor Arm Replacement Procedure” on page 8-30.
Figure 8-111 Sliding the Cables through the Opening
Figure 8-112 Location of Screws and Bracket
Slide Cables
Down Here
Cables in New Position
To Next Page
Loading...
