GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-136 Section 3-4 - Preparing for Installation
PRELIMINARY
3-7-7 MPEGVue Export Configuration
NOTE: MPEGVue Player is intended for secondary review and patient consultation.
3-7-7-1 Introduction
The procedures below describe how to set up the Vivid S5 N or Vivid S6 N ultrasound scanner for
MPEGVue export. This provides the user with the ability to export an entire patient exam into standard
supported media (such as, CD, DVD, or USB Memory Stick [disk-on-key]) in standard MPEG or JPG
format. The exported exam can later be read on any PC.
Media containing one or several patient exams in MPEGVue format is easily generated on the Vivid S5
N or Vivid S6 N. When exporting data from the system for this purpose, the exported examination
contains files in HTML, MPEG and JPG formats for all of the images in the exam. It also contains
measurements and reports generated and saved during the exam; the reports are all saved as files
in.CHM format.
Any media generated as MPEGvue also contains an embedded MPEGVue viewer, allowing the user to
view it on any PC without having to install any additional software.
The exported exam may be viewed on any PC operating on Windows 2000, 2003, Windows XP or
Windows Vista. This can prove useful in many situations - for example, when sending patient data for
a second opinion, for academic lectures, conferences, presentations, etc. Another way of using this
feature is to directly provide the patient with an MPEGVue disk (CD or DVD) containing, for example,
an OB exam.
3-7-7-2 Preparations
Obtain local IP addresses that will allow you to set up the system and the remote computer properly.
This information is available from the local system administrator.
3-7-7-3 Configuring the Vivid S5 N or Vivid S6 N for MPEGVue Export
1) Press the Config (or F2) button and log on as Adm, as described in ‘Log On to the System as ADM”
on page 4-10.
2.) Select Connectivity.
3.) Select Dataflow.
To Next Page
Loading...
