GE Vivid S5 N - 8-6-4-5 Hard Disk Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-123
PRELIMINARY
8-6-4 Hard Disk Replacement Procedure (cont’d)
4) Working from the side of the cage, use a small Phillips screwdriver to loosen and remove the screw
from the metal securing plate that holds the Hard Disk in position (as shown in Figure 8-152 below).
Figure 8-152 Loosening the Screw from the Metal Securing Plate
5) Using a finger and thumb, grip the metal plate firmly and pull to the left to slide the Hard Disk straight
out of the cage assembly - see Figure 8-153 below.
Figure 8-153 Removing the Hard Disk
8-6-4-5 Hard Disk Installation Procedure
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access codes
Screw
Screwdriver
Metal Securing Plate
(attached to Hard Disk)
Screw
Hard Disk
Metal Securing Plate