GE Vivid S5 N - 8-2-6-4 Front Cover Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-19
PRELIMINARY
8-2-6 Front Cover Replacement Procedures (cont’d)
8.) Tilting the cover away from the main assembly frame (to clear the keyboard), continue pulling it
towards you until it is completely removed from the system.
8-2-6-4 Front Cover Installation Procedure
1) Return the front cover to its original position at the front of the main assembly frame, taking care to
tilt it sufficiently so that the upper portion clears the keyboard, and the lower portion overlaps the
system chassis correctly on either side.
2) Push the upper portion of the cover onto the main assembly frame until it clicks into the
snap-lock securing clip (refer to Figure 8-18 on page 8-17).
3) Push the lower portion of the cover onto the main assembly frame until it clicks into the
snap-lock securing clip (refer to Figure 8-18 on page 8-17).
4) Return the screws (previously removed) to the securing tabs each side of the cover and tighten
securely.
5) Install the left and right side covers, as described in “Left Side Cover Installation Procedure” on
page 8-7 and “Right Side Cover Installation Procedure” on page 8-5.
6.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24