GE Vivid S5 N - 3-7-3-6 Configuring the Vivid S5 N; Vivid S6 N Remote Path

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-111
PRELIMINARY
3-7-3-6 Configuring the Vivid S5 N / Vivid S6 N Remote Path
NOTE: Before starting this procedure, verify that the destination PC / Network has a Shared folder
(remote path) with user permissions. Refer to section 3-7-9-1-1 on page 3-146 for creating a
new user in the remote PC or network.
NOTE: The paths below (refer to Figure 3-129) are used as follows:
• Save As PDF Network Path-used for saving system Reports as PDFs.
• Remote Path-used for Save As, Export from Q-Analysis, and for exporting error logs with
“Alt+D”.
1.) From the system keyboard press Config and log on as an ADM user with the appropriate password.
2.) Click Connectivity (from the bottom row of buttons) on the screen and select the Tools tab.
The Tools screen opens - see Figure 3-129.
3.) Under “Save As PDF Network Path”, in the Remote Path field, type the remote path.
For example, in Figure 3-129 type: \\IP ADDRESS\SHARE, where directory is the name of the
shared folder in the destination PC.
4.) Click Check to verify the connection.
NOTE: When clicking the Check button, you might momentarily see a “failed” message that disappears
if you click Check a second time. The system will then confirm the setting.
5.) Under “Setting for Remote Path used for Save As...”, type the remote path as follows:
\\IP ADDRESS\SHARE.
6.) Click Check to verify the connection.
Figure 3-129 Tools Screen
Save AS PDF Network Path
Remote Path
Configurable Remote Path User