GE Vivid S5 N - 3-7-7-4 Exporting to MPEGVue

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-139
PRELIMINARY
Note: Step 7 is recommended for the first transfer of MPEGVue files. This step is not needed for
Windows XP nor for Windows Vista. After initial transfer of MPEGVue, it is recommended
to disable this check box.
3-7-7-4 Exporting to MPEGVue
When exporting to MPEGVue, the Media can be one of the following supported types:
•CD
•MOD
• USB Memory stick (disk-on-key)
1.) Insert the required media into the appropriate drive (or USB port), when applicable.
2.) From the main screen, trackball to the Patient button and press SET
.
3.) End the current exam (if still open), and select Patient-List.
The Patient List will be displayed with the following header:
4.) Trackball to the Export softkey in the bottom menu shown below and press SET
.
The Export dialog box opens.
5.) Under Export To: select To MPEGvue in the combo-box on the right, as shown in Figure 3-162.
6.) Click OK.
The Patient List screen is displayed with the following header:
7.) Trackball to the required Patient File and select it by pressing SET
.
To select more than one Patient File from list, use the <Shift> key together with SET
8.) When ready, after the required Patients Files have been selected (highlighted,) press the COPY
button.
Figure 3-162 Export Dialog Box