GE Vivid S5 N - 3-7-2-4 Wireless Network Configuration; 3-7-2-4-1 Configuring the Wireless Network Adaptor

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-105
PRELIMINARY
3-7-2-4 Wireless Network Configuration
The following procedure is used to configure the Vivid S5 N or Vivid S6 N system for a wireless network
environment.
NOTE: A Wireless Network adaptor must be connected to the lower USB port located at the rear of the system.
NOTE: USB ports located at the rear of the system will be activated only after the system has loaded the main
application software.
NOTE: Do not use any other type of wireless adaptor other than the Linksys
®
WSUB54GC WLAN card.
3-7-2-4-1 Configuring the Wireless Network Adaptor
1.) From the default scanner screen, press CONFIG (F2) and log on as Adm, as described in ‘Log On
to the System as ADM” on page 4-10.
2.) Select CONNECTIVITY
(lower part of window).
3.) Select the TCP/IP
tab.
4.) Click the Advanced Settings button.
Figure 3-120 Wireless Network Adaptor Connected to Lower USB Port
Wireless Network Adaptor
Connected to Lower USB Port