GE Vivid S5 N - 8-7-3-4 Lower Arm Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-196 Section 8-7 - Mechanical Components Replacement Procedures
PRELIMINARY
10) Remove the Lower Arm from the system, as shown in Figure 8-247.
8-7-3-4 Lower Arm Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the Lower Arm Removal Procedure.
1) Working from the front of the system, return a new Lower Arm to the appropriate position as shown
in Figure 8-207 on page 8-165.
2.) While supporting the Lower Arm with one hand, connect the Ground lead.
3) Return and fasten the Lower Arm securing pin (previously removed) on the right side of the lower
arm - Figure 8-246 on page 8-195.
4) Return and fasten the Lower Arm securing pin (previously removed) on the left side of the Lower
Arm - Figure 8-246 on page 8-195.
Figure 8-247 Removing the Lower Arm