GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-126 Section 8-6 - Lower Section Components Replacement Procedures
PRELIMINARY
5.) Insert the appropriate software installation CD into the CD drive.
The following options are displayed:
NOTE: If you need to abort the process at this stage, prior to formatting, do so by pressing the On/Off
switch and holding down for a few seconds until the system shuts down.
6.) Select the appropriate formatting action corresponding with your system’s software installation.
The following screen displays:
7.) Select “Y” to continue with the formatting process or “N” to restart the procedure.
The system will start the formatting procedure and reboot automatically.
After rebooting, the system will boot from the software installation CD.
8.) Perform a “Full Clean Install” software procedure corresponding to the BT level of your system.
- Refer to the “Software Upgrade Procedure Overview” on page 8-207.
Note: IMPORTANT - if both the Hard Disk and Back End are being replaced simultaneously, it is
necessary to re-configure the LCD type as described in “Display Type Setup” on page 6-8.
9.) When done, proceed to perform the following functionality tests:
- “Software Configuration Checks” on page 4-45
- “Calibration” on page 7-12
- “Full System Test” on page 7-11
10.)After you have completed the formatting procedure, store the Formatting Utility Disk at the
customer’s site where it can be accessed for future use.
To Next Page
Loading...
