GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-211
PRELIMINARY
8-8-2 Preparation (cont’d)
4.) Under Advanced, select Display Control, then press <Enter>.
5.) From the available options, change the Display Mode to CRT+LCD.
6.) Check that Flat Panel Type is set to SVGA.
Figure 8-262 Changing Display Control Mode
Figure 8-263 Display Mode - CRT+LCD
Figure 8-264 Flat Panel Type - SVGA
To Next Page
Loading...
