Adjustment Tools
For adjustments requiring a nonmetallic tuning tool, use fiber tuning tool, HP part number
8170-0033. For adjustments to the IF Bandpass, use tuning tool, HP part number 8710-1010.
Never try to force an adjustment control. This is especially critical when tuning variable
capacitors or slug-tuned inductors.
Required service accessories, with part numbers, are listed in “Service Kit” in Chapter 1.
Instrument Service Position
Refer to Chapter 3 for information on removing the analyzer cover assembly and accessing all
internal assemblies.
Adjustment Procedures 2-3
To Next Page
Loading...
