Assembly Changed
or Repaired
AlAl
Keyboard
No related adjustment
AlA
RPG
No related adjustment
A2 Controller
Display Adjustment
A3 Interface
A4 Log Amp/Cal Osc
A5 IF
A6 Power Supply
A6Al
HV Module
A7
1ST
LO
Distribution Amplifier
A8 Low Band Mixer
A9 Input Attenuator
A10 Tracking Generator
All YTO
Table 2-1. Related Adjustments (1 of 2)
Perform the Following Related Adjustments in the Order Listed
If the old EEROM cannot be used in a new A2
or if an EEROM must be replaced, the following
adjustments must be performed:
External Mixer Amplitude Adjustment
Frequency Response Adjustment
Display Adjustment (Fast Zero Span)
Frequency Response Adjustment
Display Adjustment (Fast Zero Span)
Demodulator Adjustment
IF Amplitude Adjustment
DC Log Amplifier Adjustment
IF
Bandpass
Adjustment
IF Amplitude Adjustment
High Voltage Power Supply Adjustment
Display Adjustment
High Voltage Power Supply Adjustment
Display Adjustment
First LO Distribution Amplifier Adjustment
Frequency Response Adjustment (or perform the Frequency
Response performance test in the
HP 8560A Installation and Verification Manual.
The adjustment must be performed if the performance test fails.)
Frequency Response Adjustment
Frequency Response Adjustment (or perform the Frequency
Response performance test in the
HP 856OA Installation and Verification Manual.
The adjustment must be performed if the performance test fails.)
Tracking Generator Power Level Adjustment
Frequency Response Adjustment
YTO Adjustment
Frequency Response Adjustment (or perform the Frequency
Response performance test in the
HP 8560A Installation and Verification Manual.
The adjustment must be performed
if
the performance test fails.)
kdjustment
Number
2
15
10
2
10
2
13
4
5
3
4
1
2
1
2
8
10
10
10
9
10
7
10
2-4 Adjustment Procedures
To Next Page
Loading...
