HP 8560A

5
Major Assembly and Cable Locations
Introduction
This chapter identifies the module’s assemblies and cables and contains the following figures:
Page
Figure 5-l. Hinged Assemblies ...........................................
5-4
Figure 5-2. Top View (A2 Unfolded)
......................................
5-4
Figure 5-3. Top View (A2 and A3 Unfolded)
...............................
5-5
Figure 5-4. Top View (A2, A3, A4, and A5 Unfolded)
.......................
5-6
Figure 5-5. Bottom View (Al5 Unfolded)
.................................
5-7
Figure 5-6. Bottom View (Al5 and Al4 Unfolded)
.........................
5-8
Figure 5-7. Front End ..................................................
5-9
Figure 5-8. Rear View .................................................
5-10
Use the list below to determine the figure(s) illustrating the desired assembly or cable.
Assemblies .......................................................
..Figur e
Al Front Frame ........................................................
5-6
AlAl Keyboard
......................................................
..5- 6
A2 Controller
......................................................
5-1, 5-2
A3 Interface .....................................................
..5-1.5- 2
A4 Log Amplifier/Cal Oscillator
.....................................
5-1, 5-3
A5 IF Filter
.......................................................
5-1,5-4
A6 Power Supply .......................................................
5-4
A6Al High Voltage Module ..............................................
5-4
A7 LO Distribution Amplifier ............................................
5-7
A8 Low Band Mixer ....................................................
5-7
A9 RF Attenuator
....................................................
..5- 7
A10 Tracking Generator
...............................................
..5- 7
AllYTO
...........................................................
..5- 7
Al2 (Not Assigned)
Al3 Second Converter ................................................
..5- 7
Al4 Frequency Control
.............................................
5-1, 5-6
Al5 RF
....................................................... 5-1,5-5,5-6
Al7 CRT Driver .....................................................
..5- 4
Al8 CRT Assembly ....................................................
5-4
Major Assembly and Cable Locations 5-l